Fostex LIVE RECORDING MIXER LR16 - Manual (Page 55)

55
Model LR16 [Recorder functions / Recording/playback]
Punch in/out using a footswitch
You can perform punch in/out using a
footswitch connected to the [FOOT SW] jack on
the rear panel of the main unit.
The following procedure example describes how
to perform punch in/out to track 3 of the project
whose tracks 1 through 8 have been recorded.
It is assumed that you have completed source
connection, level adjustment, mixer settings, etc.
Press down the
footswitch (punch in).
Press down the footswitch again
(punch out).
Playback Playback Recording
I INSERT INSERT INSERT INSERT INSERT INSERT
INPUT
AUX SEND (-2dBu) EFF SEND (-2dBu) P (+4dBu)
ST MIX OUT (-10dBV) USB MIDI OUT FOOT SW CONTROLLER PANEL LOCK
LOCK
PHANTOM POWER
<Note>: To perform punch in, do not for-
get to hold down the [PLAY] key when
pressing the [RECORD] key.
(8) At the punch out point, press only the
[PLAY] key.
Track 3 is punched out (switches from
recording to playback).
(9) Press the [STOP] key to stop the recorder,
and locate the recorder back to the punch
in position.
<Note>: You cannot perform punch in/
out successively without stopping the re-
corder. To perform more than one punch
in/out operation, stop the recorder each
time you finish punch in/out.
(7) At the punch in point, press the [RECORD]
key while holding down the [PLAY] key.
Track 3 is punched in (switches from
playback to recording).
(2) Turn off the [NEW PROJECT] key in the
recorder section.
(3) Turn on the [REC TRACK SELECT] key for
track 3.
(4) Set the [SOURCE] switches on mixer
channels 1 through 8 to "TRK" (
).
The playback signals of tracks 1 through 8
are routed to the mixer input channels.
(1) Connect an unlatched footswitch to the
[FOOT SW] jack.
<Note>: Do not use a footswitch which is
not the unlatched type. Connecting an
improper footswitch may cause malfunc-
tion.
<Note>: To use a footswitch for punch in/out,
the "Foot SW" item in the "System" menu of the
MENU mode must be set to "P I/O". Though it is
set to "P I/O" by default, if it is set to an option
other than "P I/O", change it to "P I/O" (see page
77 for details).
<Memo>: By pressing the [STOP] key on
the mixer section, the recorder automati-
cally skips to the beginning of the project
(ABS 0) and stops.
(10) Press the [PLAY] key to play back the
project to check the result.
If you are not satisfied with the result, roll
back the previous project data before punch
in/out (see page 76 for details).
Footswitch