Furuno NAVPILOT 511 - Manual (Page 69)

MN-1
MENU TREE
[MENU] key
PARAMETER SETUP SEA STATE ( FULL-AUTO, SEMI-AUTO, MANUAL-CALM,
MANUAL-MODERATE, MANUAL ROUGH)
DEVIATION LEVEL* ( AUTO, LEVEL)
MANUAL PARAMETERS
AUTO TRIM
(OFF, ON, 1-100, 40)
ADVANCED AUTO ( OFF, ON)
AUTO NET TOWING ( OFF, ON)
NAV MODE ( XTE, COURSE)
NAV SRC ( PORT 1, PORT 2, BOTH)
RADIUS OF ORBIT (0.05 to 9.99 nm, 0.10 nm)
SPIRAL SPEED (0.1 to 8.0 kt, 1.0 kt)
FISH MODE ( OFF, ORBIT TO STBD,
ORBIT TO PORT, FIGURE EIGHT)
WAYPOINT SWITCHING ( AUTO, MANUAL)
SPD CALC. ( SOG, STW, MANUAL)
SYSTEM DATA
SYSTEM SETUP KEY BEEP ( ON, OFF)
LOCK (LOCK, UNLOCK)
PANEL DIMMER (1 to 8, 8)
STBY mode menu
ALARM SETUP AUDIO ( INTERNAL BUZZER, INTERNAL +EXTERNAL)
ALARM INTERVAL ( SHORT, LONG, CONTINUE)
WATCH ALARM (OFF, ON)
DEVIATION ALARM (1 to 90 , 30 )
XTE ( OFF, ON)
SPD ( OFF, UNDER, OVER, INSIDE, OUT)
DPT ( OFF, SHALL, DEEP, INSIDE, OUT)
TMP ( OFF, UNDER, OVER, INSIDE, OUT, CUR.)
TRIP LOG ALARM ( OFF, ON)
CLEAR TRIP LOG ( NO, YES)
MESSAGE (Shows error messages.)
CONTRAST/BRILLIANCE (Contrast: 1 to 16, 10, Brill: 1 to 8, 8)
TEST OFF
PROCESSOR UNIT
CONTROL UNIT
HEADING SENSOR
KEYBOARD TEST
SCREEN TEST
RUDDER TEST
*: Available only when FULL-AUTO is selected at SEA STATE.