Fisher-Price SWING 'N MEALS 79739 - Manual (Page 4)

Assembly
4
• Place the front base on a flat surface.
• Position a front leg so that the tapered end is downward,
as shown.
• While pressing the button on one of the front legs, insert it
into the front base. Push down on the front leg until the
button “snaps” into the hole in the front base.
• Repeat this procedure to assemble the other front leg to
the front base.
Front Base
Tapered End
Tapered End
Front Legs
IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use
if any parts are missing or broken. Contact Fisher-Price® for replacement parts and instructions if needed. Never substitute parts.
• While standing on the front base, pull the front legs up.
The front legs should remain secured to the front base.
If you can remove the front legs, you have not assembled
them correctly to the front base. Reread and repeat
assembly step 1.
• Position the rear leg with housing so that the hub is inward.
• While pressing the upper button on front leg, insert it into
the rear leg with housing slot, as shown. Push the front leg
until the button “snaps” into the hole in the rear leg with
housing.
• Repeat this procedure to assemble the rear leg with motor
housing to the other front leg.
• Pull the front legs down to be sure they are secure in the
housings. If you can remove them, you have not assembled
them correctly. Please re-read and repeat this assembly step.
• Pull both rear legs out until they “snap” into place.
Press
Button
Press
Button
Hubs
Rear Leg
with
Housing
Slot
Rear Leg
with
Motor
Housing
Front
Legs
Press
Buttons
Front Legs Pull Up
Pull Up
Pull
Rear
Leg Pull
Rear
Leg
Front Base
1
2
3
4
79739b-0920.qrk 10/25/01 11:11 PM Page 4