Festool TS 75 EQ - Manual (Page 5)

5
Technical data
Power consumption 1 600 W
No load speed 1350 - 3550 rpm
Angele of cut 0° - 45°
Depth of cut at:
90° 75 mm (3.0")
45° 56 mm (2.2")
Saw blade diameter 210 mm (8.27")
Saw blade hole diameter 30 mm (1.18")
Weight 6.1 kg (13.4 lbs)
Safety acc. to UL 60745, CSA C22.2 No. 745
Symbols
V volts
A amperes
Hz hertz
W watt
~
alternating current
n
0
no load speed
Class II Construction
rpm revolutions per minute
Functional description
1.1
1.2
1.3
1.4
1.5
1.6
1.7
1.9
1.8
1.1 Protective cover
1.2 Cutting depth scale
1.3 Cutting depth end stop
1.4 Setscrew for angle adjustment
1.5 Hexagon socket wrench
1.6 Saw
table
1.7 Switching on and unlocking block
1.8 On/Off
switch
1.9 Guide jaws
Use for intended purpose
The hand-operated circular saw TS 75 EQ is
designed exclusively for the sawing of wood,
wood-like materials and plastics. With the special
saw blades for aluminium offered by Festool,
these machines can also be used for sawing
aluminium.
The machine should not be converted or modifi ed,
e.g. for any other form of use, other than as
specifi ed in these operating instructions.
The user shall be liable for damages
and accidents resulting from incorrect use.
Electrical connection
The network voltage must conform to the voltage
indicated on the rating plate. A 16 A safety fuse
(for 120 V) or a corresponding protective circuit-
breaker is required.
See the following fi gure for connection and dis-
connection of the power cord.
Always switch the tool off before con-
necting or disconnecting the power cord!
2
Extension cable
If an extension cable is required, it must have
a suffi cient cross-section so as to prevent an
excessive drop in voltage or overheating. An
excessive drop in voltage reduces the output and
can lead to failure of the motor. The table below
shows you the correct cable diameter as a function
of the cable length for the TS 75 EQ. Use only
U.L. and CSA listed extension cables. Never use
two extension cables together. Instead, use one
long one.
Total Extension Cord
Lenght (feed)
25 50 100 150
Cord size (AWG) 14 12 10 -
Note: The lower the AWG number, the stronger
the cable.
Tool settings
Always disconnect the plug from the
power supply before making any adjustments
to the circular saw or installing or removing any
accessory!
Electronic control
The TS 75 EQ has solid shaft electronics with the
following functions: