FUJITSU 280X1024@75Hz User Manual
Page 8
Mode
Resolution
Horizontal(KHz)
Vertical(Hz)
1
640x400
31.469
70.087
2
640x480
31.469
59.940
3
640x480
37.861
72.809
4
640x480
37.500
75.000
5
720x400
31.469
70.087
6
800x600
35.156
56.250
7
800x600
37.879
60.317
8
800x600
48.077
72.188
9
800x600
46.875
75.000
10
1024x768
48.363
60.004
11
1024x768
56.476
70.069
12
1024x768
58.038
71.918
13
1024x768
60.023
75.029
14
1024x768
48.019
60.000
15
1024x768
47.700
60.000
16
1152x864
67.500
75.000
17
1280x800
49.702
74.900
18
1280x800
62.795
60.000
19
1280x960
60.000
60.000
OPERATION
OPERATION
System setting menu
Language: use or to select desired language.
Menu display time: use or to select the desired time for menu display.
Saving time: use or to select desired time for display so as to meet your
requirement.
Reset: reset all the set value to factory setting.
3.3 Safeguard
When the video signal of your computer exceeds the frequency range of monitor
(refer to product specification), the micro-computer of monitor will turn off the sync
signal of horizontal and vertical for the purpose of monitor protection, please refer
to the illustration below. The monitor will enter saving mode after few seconds,
and the power indicator will light red. Please
Return: back to previous menu.
set the output frequency of your computer
within the acceptable range of monitor so that
the monitor can work normally.
OUT OF RANGE
Return
Language
English
OSD Timeout
60
Power Save
8
Reset
4 : 3
OFF
USER
1280X1024@75Hz
3.4 Setting of display mode
With standard VESA and DDC function, the monitor will scan frequency, output
power, performance etc and transfer to PC after turning on when you use the
video card with VESA DDC1/2B function. And it will identify the connection mode
of display and select the proper resolution.
The preset mode before leaving factory is as below:
MENU
S e l e c t
- + M o v e
Display mode:when setting OFF,it is display mode,whensettingON,
it will be 4:3 display mode
Exit and signal resource selection menu
Select terminal input: select input terminal for signal input (option)
Exit: exit OSD menu
Exit
VGA
√
DVI
MENU
S e l e c t
USER
1280X1024@75Hz
- + M o v e
Note: Hot Key of volume, brightness, contrast
Without OSD mode, your may press " " button to call volume adjustment directly,
when the volume menu is not exit, please press "MENU" to call brightness and
contrast adjustment, you may use " / " to adjust it to optimum.
page 11
page 12