Fostex Speaker User Manual
Page 6
Product Specifications
Cable and Wiring Information
Product Cleaning Instructions
Cabinet Dimensions
Amplifier Power
Amplifier Distortion
Amplifier Signal to Noise Ratio
Net Weight
11 11/16" (W) x 15 3/4" (H) x 16 1/2" (D) includes heatsink
18.5 Kg
16 Kg
35.3 Pounds
40.8 Pounds
Cross Weight (includes all packing material)
Subwoofer Frequency Response
Subwoofer Phase
XLR Outputs Frequency Response
US : 120VAC ~ 60Hz
110Watts@1%
Power Requirements
EUR/UK : 230VAC ~ 50/60Hz
> 80dB
<0.002
%
THD @ 50 Watts / 4Ohm
Product improvement may warrant a change of specifications, newer materials or cosmetics, Changes in specifications
and features may be made without notice or obligations.
Use high-quality, shielded cables to connect your mixing console, workstation or other source to your
monitors. Foil-shielded cables, such as Beholden 8451, 8761, or 9501 should do quite well. Other high
quality cables are available and those that incorporate better shielding will yield an overall higher noise
rejection, lowering your systems susceptibility to external interference. Another important tip to keep in
mind when wiring your system is to route all line level cables away from the AC and other power
sources, this will reduce the probability of having AC hum emanating from your studio monitors.
297mm (W) x 400mm (H) x 420mm (D) incudes heatsink
385mm (D) cabinet only - no heatsink
Free Field Frequency Response: 20Hz ~ 70Hz
Low Frequency Cutoff : 65Hz (-10dB)
Phase switch : + and -
HOT (+)
XLR
PIN 2
PIN 3
PIN 1
TIP
TIP
RING
COLD (-)
SHIELD (
GROUND
)
Prior to cleaning the PM0.5-Sub MK
Ⅱ
the power must be disconnected from. Once the power has been
terminated, cleaning can be accomplished using a damp (not wet) cleaning rad. Do not use any abrasive
or chemically harsh cleaning fluids.
Regular dusting with damp rag cleaning will keep your product looking new for years.
Power Consumption
Driver. 8" Magnetically shielded
US : 75 Watts
EUR/UK : 80 Watts
p-6
RCA
TRS
SHIELD
SHIELD
15 1/8" (D) cabinet only - no heatsink