Electrical data, Electrical safety – Friedrich 230 Volts US10 User Manual

Page 5

Advertising
background image

5

Electrical

Data

Do not under any
circumstances cut
or remove the
grounding prong
from the plug.

Line Cord Plug

Use Wall Receptacle

Power Supply

Line Cord Plug

Use Wall Receptacle

Power Supply

Power supply cord with
3-prong grounding plug

Do not under any
circumstances cut
or remove the
grounding prong
from the plug.

Power supply cord with
3-prong grounding plug

Standard 125V, 3-wire grounding
receptacle rated 15A, 125V AC

Parallel
type

Tandem
type

Perpendicular
type

Standard 250V, 3-wire grounding
receptacle rated 15A, 250V AC

Use 15 AMP time
delay fuse or 15 AMP
circuit breaker.

Use 15 AMP
time delay fuse or
circuit breaker.

Use 20 AMP
time delay fuse or
circuit breaker.
Refer to the nameplate
for correct fusing.

Do not under any
circumstances cut
or remove the
grounding prong
from the plug.

Power supply cord with
3-prong grounding plug

Standard 250V, 3-wire grounding
receptacle rated 20A, 250V AC

Electrical Data

USE OF EXTENSION CORDS

Because of potential safety hazards, do not use an extension cord.

Electrical Data(For 115V model)

Electrical Data(For 230/208V model)

ELECTRICAL SAFETY

All wiring should be made in accordance with local electrical codes and regulations.
NOTE : Aluminum house wiring may pose special problems. Consult a qualified electrician.

IMPORTANT GROUNDING INSTRUCTIONS
Air conditioner has a three-prong grounding plug
on its power supply cord, which must be plugged
into properly grounded three-prong wall
receptacle for your protection against possible
shock hazard.

FUSE – Use a time-delay fuse or circuit breaker.
Refer to the nameplate for proper power supply
requirements.

208, 230, and 208/230 VOLT UNITS

These units are equipped with a three-prong
grounding plug on the power supply cord, which
must be plugged into a matching, properly
grounded three-prong wall receptacle for your
protection against possible shock hazard. If such
an outlet is not present, one must be installed by a
qualified electrician in accordance with the National
Electrical Code and local codes and ordinances.

Advertising
This manual is related to the following products: