Fisher & Paykel Active Smart - Manual (Page 8)

8
Installation - Four Essential Requirements
4. Ventilation and Installation
To ensure adequate ventilation for your refrigerator or freezer, allow a minimum of 2” (50mm) of
airspace above the cabinet, 1” (20mm) on each side, and 1 ⁄” (30mm) at the rear. (See diagram 1).
The appliance is intended to be placed against a wall with a free distance not exceeding
3” (75mm).
If building the appliance into a cupboard, follow installation instructions provided with the
integration kits.
Ensure the front face of the bench is aligned to the front corner edge of the refrigerator door. This
will allow the door to fully open. (See diagram 2).
If placing the refrigerator in a corner allow 5 ⁄” (140mm) clearance for the door to be able to
open. (See diagram 3).
Before Placing Food in the Fresh Food or Freezer Compartments
Remove all packaging. Ensure that all transit clips are removed from the refrigerator. These are
small rubber stops located at the back of the shelves.
Allow the refrigerator and freezer to run empty for 2 – 3 hours to allow each compartment to cool
to the appropriate temperature.
Clean the inside of the appliance with warm water and a little liquid detergent to remove
manufacturing and transportation dust.
The appliance may have an odor on its initial operation, but this will go when the refrigerator and
freezer have cooled sufficiently.
Energy Efficiency
Do not cover your appliances with any material that will prevent air from flowing around the
cabinet sides.
Do not leave the door open for any longer than is necessary.
Allow good clearances in front of the air ducts within the cabinet for maximum cold
air distribution.