Friedrich CP05 CP Line - Manual (Page 6)

6
ON/OFF TIMER
OPERATION MODE SELECTOR
POWER
TEMPERATURE SETTING
• These buttons control the temperature
of the room. The temperature can be set within a range of
60
°
F to 86
°
F, in increments of 1
°
F.
FAN SPEED
• Everytime you push this button it will rotate between the
following fan speeds:
High (F3) Low(F1) Medium (F2) High (F3)
MONEY SAVER
1
2
3
4
6 5
1
2
3
4
5
6
The fan stops when the compressor stops cooling.
• Approximately every 3 minutes the fan will turn on and sample
the room air to determine if more cooling is needed.
ON-If unit is off, use Timer to set number of hours before unit starts.
• Push Timer button to advance setting from 1hr - 2hrs - .....12 hrs
maximum.
OFF - You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the temperature
setting will rise 2
°
F after 30 min, and once again after another
30min.
• Push Timer button to advance setting from 2 hrs....12 hrs
maximum.
• To turn the unit ON, push the button. To turn the unit OFF, push
the button again.
• This button takes priority over all other buttons.
• When you first turn it on, the unit is on the High Cool mode and
the temperature is set at 72
°
F.
Power
Temp
Fan Speed
Timer Mode
Money
Saver
5
1
6
3 4
2
• Everytime you push this button, it will rotate between the COOL,
FAN and DRY modes.
How to operate your Friedrich
The controls will look like the following.
Control and Remote Control Operations
1. Remove the cover from the back of the remote
control.
2. Insert two batteries.
• Be sure that the (+) and (-) directions are correct.
• Be sure that both batteries are new.
3. Re-attach the cover.
• Do not use rechargeable
batteries. Such batteries
differ from standard dry
cells in shape, dimensions,
and performance.
• Remove the batteries from
the remote control if the air
conditioner is not going to
be used for an extended
length of time.
How to Insert Batteries