Fostex X-34 - Manual (Page 13)

13
Model X-34 Owner’s Manual
<Note>
When Track Down is “ON,” the REC TRK switches are
disabled. Also, if the Auto Bounce button or Track Down
button is switched on and off while any one REC TRK
switch is set to REC READY state, the selected REC
TRK switch will be canceled. In this case, reselect the
recording track using with the REC TRK switch.
8. While playing the synthesizer, gradually raise
the channel 1 input/playback level fader.
As the fader is raised, the level meter 1 will start to
blink.
Adjust the recording level by raising the input/
playback level fader to a point where the meter [3]
blinks at maximum sound volume.
9. You can adjust the headphone or monitor
s p e a k e r s o u n d vo l u m e by t u r n i n g t h e
MONITOR knob, and the channel 1 MON MIX/
AUX knob.
10. Use the EQ knobs on channel 1 to adjust the
tone.
11. Position the monitor sound image using the
channel 1 PAN knob.
<Note>
If you had selected a track other than track 1 as the
recording destination, use the MON MIX/AUX knob and
PAN knob of the corresponding track channel. For
example, if the sound source is input at LINE IN/INSERT
1 and to be recorded to track 2, use the MON MIX/AUX
knob and the PAN knob on channel 2.
12. After adjusting the recording level and tone,
press the REC button (the PLAY button will also
depress) to start recording.
The REC indicator lights up in red.
13. When you finish recording, press the STOP
button.
Recording will be canceled (the REC indicator turns
off).
14. Press REC TRK switch 1 repeatedly to turn off
the record track indicator.
15. Press the REW button and rewind the tape to
counter [000].
Try recording on tracks 2-4 in the same way.