Fisher & Paykel CG122 - Manual (Page 25)

23
Gas burners
The knob (Fig. 23) controls the flow of gas through the safety valve.
OFF = closed valve
HI = maximum flow
LO = minimum flow
You can choose to cook at any heat between LO and
HI , but never between HI and OFF .
Using the burners
1 Choose the control knob for the burner you want to use.
2 Press the knob down gently and turn it counterclockwise
to the HI position. The ignitors on all the burners will
spark.
Hold down the knob for approximately 10 seconds
after the burner has lit. Releasing the
knob too soon will extinguish the flame.
3 Adjust the flame anywhere between the HI a nd LO
positions. Do not adjust the flame between HI and OFF .
Note: if the burner does not light within 15 seconds,
turn the control knob off and wait at
least one minute before trying again.
4 After use, always turn the knobs to the OFF position and
close the gas shut-off valve on the main gas supply line.
Flame failure safety feature
Your cooktop has a flame failure safety device; each burner is equipped with a flame failure
probe as well as the ignitor (see Fig. 25).
The flame failure probe cuts off the gas supply to the burner if the flame is blown out. If this
happens, turn off the burner and do not try to light it again for at least one minute (to allow the
gas to disperse).
Using your cooktop
Fig.23 Burner control knob
(knobs may vary)
Fig.24 Pushing then
turning the control knob
(knobs may vary)
US CA