Fisher-Price 71592 - Manual (Page 11)

11
PROBLEM PROBABLE CAUSE SOLUTION
Weak reception Out of range or insufficient signal Test reception by moving the transmitter and/or receiver to different locations
throughout the house. Relocate the transmitter and/or receiver.
AC adaptor cord(s) not fully extended Fully extend AC adaptor cord(s).
Improper antenna position Make sure antennas are pointing upward.
Receiver variable lights Weak or dead battery in receiver Replace the battery in the receiver with a fresh 9V alkaline battery or
display does not light use the AC adaptor.
Interference Signal interference due to another Change channel switch on both transmitter and receiver to the other channel.
(buzzing, static, etc.) nursery monitor or cordless
and signal indicator on telephone, etc.
receiver is ON
Channel switches not on same Set channel switch on transmitter and receiver to the same channel.
setting (channel)
Interference Signal interference due to other Change channel switch on both transmitter and receiver to the to the
(buzzing, static, etc.) nursery monitors or cordless other channel.
and signal indicator on telephones, etc.
receiver is OFF
Identify and eliminate source of interference. Do not use more than one
transmitter at the same time in the same house.
Channel switches not on same Set channel switch on transmitter and receiver to the same channel.
setting (channel)
Receiver power is ON but transmitter Make sure the transmitter is ON. The power indicator should be lit.
power is OFF
Code switches in receiver and Reset code switches in receiver and transmitter so that they match.
transmitter do not match
Interference Signal interference due to another Make sure transmitter power is ON.
(garbled voices) and Fisher-Price ® Direct Link Privacy Monitor ™
signal indicator on Change channel switch on both transmitter and receiver to the other channel.
receiver is ON
We recommend “Checking Privacy” periodically. See page 6.
Feedback Receiver is too close to the transmitter Move receiver further away from transmitter.
(squealing or whistling)
Volume is set too high Lower volume on the receiver.
All five bars on the Receiver power is ON but Turn the transmitter power ON.
receiver variable lights transmitter power is OFF
display light
Out of range or insufficient signal Move the receiver closer to the transmitter.
Channel switches not on same Set channel switches on transmitter and receiver to the same channel.
setting (channel)
AC adaptor not properly connected Check AC adaptor jack-to-socket and plug-to-outlet connections.
to transmitter
PROBLEMS AND SOLUTIONS