FUJITSU FTR-G1 - Manual (Page 2)

2
FTR-K1 SERIES
* 1 Need to consider the heat to PCB when max. current is more than 10A
* 2 Minimum switching loads mentioned above are reference values. Please perform the confi rmation test with actual
load before production since reference values may vary according to switching frequencies, environmental conditions
and expected reliability levels.
FTR-G1 SERIES
 SPECIFICATION
Item FTR-G1
Contact
Data Confi guration 1 form C
Material Silver-tin oxide indium (AgSnO
2
)
Contact voltage drop Max. 100mV at 1A, 6VDC (after stabilization)
Contact rating 25A at 14VDC (locked motor load)
Max. carrying current * 1 25A/1 hour (25 °C, 100% rated coil voltage)
Max. switching voltage 16VDC (reference)
Max. switching current 35A (reference)
Min. switching load * 2 1A, 6VDC
Life Mechanical Min. 1 x 10 6 operations
Electrical
* Min. 100 x 10 3 operations,
14VDC, 25A inrush power window motor
(1 operation: 1 forward and 1 reverse)
* Min. 100 x 10
3 operations
14VDC, 20A inrush door locked motor
Coil Data Rated power 640mW
Operate power 237mW
Operating temperature range -40 °C to +85 °C (no frost)
Timing Data Operate (at nominal voltage) Max. 10 ms (without bounce)
Release (at nominal voltage) Max. 5 ms (without bounce, no diode)
Insulation Resistance (initial) Min. 100MΩ at 500VDC
Dielectric withstanding
voltage
Open contacts 500VAC , 1 min.
Between coil
and contacts
500VAC, 1 min.
Other Vibration resistance Misoperation 10 to 55Hz double amplitude 1.5mm
Shock
Misoperation 100m/s² minimum (10G)
Endurance 1,000m/s² minimum (100G)
Weight Approximately 3.5 g
Sealing Plastic sealed cat III