Fluke 2635A-PRINT 120 - Manual (Page 2)

2635A-PRINT 120, 2635A-PRINT 230
Instruction Sheet
2
Loading Printer Paper
XW Warning
If the printer has been recently used,
the print head may still be hot.
To allow continuous printing of Hydra scan data,
Continuous Forms-type paper is recommended.
Load continuous forms paper as follows (see
Figure 1):
1. Set the paper lever (located on the right-side) to
its forward position to select “Continuous
Forms”.
2. Move the bail arm lever (located on the left-side)
forward to release bail arm pressure from the
platen.
3. With the top-cover open, thread the continuous
forms paper either in from the back, under the
paper separator and down behind the platen, or up
through the slot on the bottom of the Printer.
4. Raise the paper in front of the platen to a level
above the Printer top.
5. If the paper has sprocket holes on the sides, adjust
the spacing of the sprockets on the platen to fit the
paper properly. For more details, see the User’s
Guide on the included CD-ROM.
6. With the paper in the correct position on the
platen and sprockets, move the bail arm lever
back to press the bail arm against the paper.
7. Close the top cover, making sure to thread the
paper up through the slot.
8. Using the platen knob, adjust the paper to the
right starting position with the top edge of the
paper above the bail arm.
9. Press the SELECT button on the front of the
Printer to put it on-line. The light next to the
SELECT button indicates the printer is online.
Connecting the Printer
The Printer connects directly to the Hydra’s RS-232C
connector on the Hydra rear panel, using the supplied
RS42 serial printer cable.
To simplify system setup, Printer default settings
correspond to Hydra series instruments. No
adjustments to these settings are necessary.
To set up the Printer:
1. Connect the larger 25-pin connector end of the
RS42 serial printer cable to the serial interface
connector on the Printer.
2. Connect the 9-pin connector end of the RS42
serial cable to the RS-232C serial connector on
the rear panel of the Hydra.
3. Connect power cord to the rear of the Printer, and
plug it into an appropriate power outlet.
4. Turn the Printer power on.
To set up the Hydra:
1. Check that the Hydra is set to 9600 Baud and No
Parity (refer to the proper Hydra Users Manual
for instructions). Use the SHIFT and LIST
[COMM] buttons on the Hydra front panel to
check and set if needed.
2. Set the Hydra for Autoprint mode. See the
instructions below for the appropriate model:
•
2635A Data Bucket
1. Press the SHIFT and FILES [MODE]
buttons.
2. Select PRINT (or BOTH) Destination
using up or down arrow keys.
3. Press ENTER .
4. Select ALL for the Mode.
5. Press the
ENTER key again.
•
2625A Data Logger
1. Press the SHIFT and PRINT [MODE]
buttons.
2. Select PRINT (or BOTH) Destination
using up or down arrow keys.
3. Press ENTER .
4. Select ALL for the Mode.
5. Press the
ENTER key again.
6. Check that the PRN annunciator on the
display is on.