Faber MR-11 - Manual

Halogen Bulb replacement instructions:
If your halogen bulbs need replacement, please follow
these instructions below. You will need a 1” wide
suction cup, available thru Faber or local hardware store.
Step 1: Purchase a new MR-11 or MR-16 (Pellicano),
12 volt, 20 watt halogen bulb with a glass lens cover.
Step 2: Using the suction cup gently push against the
bulb in the hood making a seal around the bulb.
Step 3: Pull down on the bulb with the suction cup, to
remove the bulb from the hood
Step 4: Place the new bulb into the hood, lining up
the bulb prongs with the holes inside the hood.
For more information please call Faber at
508-358-5353 or email [email protected]
Step 1
Step 2
Step 3
Step 4