Grizzly Magnetic Misting Unit T10121 - Manual

Specifications
Distribution Tube Overall Length • .......... 19 3 ⁄
4
"
Atomizing Tip Orifice ID
•
......................... 2mm
Construction
•
.............Steel, Brass, Aluminum
Suction Tube
•
................................... 3 ⁄
32
" x 80"
Suction Tube Filter Type • ........... Brass Wafer
Air Valve Type
•
........................ Lever and Ball
Misting Valve Type
•
............ Knob and Needle
Fitting Type • ........................ Push-On 1 ⁄
4
" NPT
Recommended Air Supply
• ........... 90-120 PSI
Weight
•
...............................................3.74 lbs
MODEL T10121
MAGNETIC
MISTING UNIT
INSTRUCTIONS
Damage to your eyes, lungs, and skin could
result from using misting unit without
protective gear, such as safety glasses,
a respirator, and rubber gloves.
COPyRIghT © MAy, 2009 By gRIzzLy INDuSTRIAL, INC.
WARNING: NO pORTION Of ThIS MANUAL MAy bE REpRODUCED IN ANy ShApE
OR fORM WIThOUT ThE WRITTEN AppROvAL Of GRIzzLy INDUSTRIAL, INC.
#CR11822 PRINTeD IN TAIWAN.
If you need help with your new misting unit, call
our Tech Support at: (570) 546-9663.
pOISON hAzARD!
Use personal protection
equipment when handling
coolants and using this
tool. follow federal, state,
coolant manufacturer
requirements to properly
dispose of coolants.
figure 1. Magnetic misting unit inventory and
controls.
Air
Valve
Distribution
Tube
Atomizing
Tip
Air Inlet
Filter
Suction
Tube
Misting
Valve
Magnetic
Base
Control
Operation
1. Close the air flow and misting valves, and use
the knob to apply the magnet and clamp the
base to a metal surface (
figure 1).
2. Connect the air inlet to a 90-120 PSI air
source, point the atomizing tip at the cutter,
and insert the suction tube into the coolant.
3. use the air valve and the misting valve to
control the misting spray so it can barely be
seen. Flooding is not required.