Gateway GT5062b - Manual (Page 52)

CHAPTER 4: Upgrading Your Computer
46
6 Remove the two drive retention screws.
7 Slide the drive forward and out of the drive bay.
8 Slide the new drive into the drive bay, line up the screw
holes on the drive bay with the screw holes on the drive,
then replace the two drive retention screws.
9 Reconnect the drive cables using your notes from
Step 4 , or according to the manufacturer’s instructions.
10 Replace the front bezel by following the instructions in
“Replacing the front bezel” on page 39 .
11 Replace the side panel by following the instructions in
“Replacing the side panel” on page 40 .
Drive retention screws
8512243.book Page 46 Monday, February 12, 2007 4:35 PM