GE 05GP005 - Manual (Page 9)

7
Location of Controls
TUNING Control
• Turn to select the station or channel
after selecting TV or RADIO with the
OFF/TV/RADIO switch.
• Refer to the channel numbers on the
VHF/UHF dial scales when choosing
a TV channel.
• Refer to the station numbers on the
FM/AM dial scales when choosing a
radio station.
OFF/TV/RADIO Switch
• Place in the OFF position to turn off
the TV/Radio.
• Place in the TV position to select a TV
channel. Select UHF or VHF by first
placing the UHF/V-HI/V-LOW
switch in the proper position and then
turning the tuning control.
• Place in the RADIO position to select
a radio station. Select FM or AM by
first placing the AM/FM switch in the
proper position and then turning the
TUNING control.
UHF/V-HI/V-LOW/Switch
• Switch must be in the TV position to
select UHF and VHF television
channels.
• Place in the UHF position to select
UHF channels (14-69). Then slowly
rotate the TUNING control until the
indicator aligns with the desired
channel number on the UHF dial
scale.
• Place V-HI position to select VHF
channels 7 through 13, and in the V-
LOW position to select VHF channels
2 through 6. Then slowly turn the
TUNING control until the indicator
aligns with the channel on the VHF
dial scales.
AM/FM Radio Switch
• Place in the RADIO position to select
AM or FM radio stations.
• Set in the AM position to select AM
stations, and FM to select FM stations.
Then slowly turn the TUNING control
until the indicator aligns with the
number of the radio station under the
FM or AM radio dial scale.
Radio Dial Scales (FM/AM)
• FM radio stations are listed under the
word FM, and AM stations are listed
under the word AM on the radio dial
scales.
VOLUME Control
• Slide to the right to increase volume.
• Slide to the left to decrease volume.
TV Dial Scales (UHF/VHF)
• UHF TV channel numbers are listed
under the UHF dial scale, and VHF
TV channel numbers are listed under
the VHF dial scale.
Control Inside the
Battery Compartment
The FOCUS control in the battery
compartment is not a customer
control. It should only be adjusted
by a qualified service technician.