Global Machinery Company VEC117 - Manual (Page 11)

11
5. Carefully remove the reflector and bulb assembly (fig. G).
6. Disconnect the bulb wire from the red power wire
(fig. H).
7. Unsnap the hairpin retaining wires from the reflector’s
flange (fig. I).
8. Using the screwdriver, loosen the retaining screw
to remove the bulb from the reflector (no need to
completely remove this screw).
9. Lift out the bulb and the attached wire (fig. J).
10. Insert the replacement bulb into the reflector’s flange.
11. Put back and secure the hairpin retaining wires
(fig. K).
12. Connect the white bulb power wire to the red power
wire (fig. L).
13. Tighten the retaining screw on the flange
(fig. M).
14. Reassemble in reverse order.
15. Operate switch to ensure proper operation of spotlight
(fig. N).
Replacing the Battery Pack
The Sealed Lead Acid Battery has a life of several years, if
recharged promptly after each use. When a fully charged
battery only provides about five minutes or less of spotlight
operation, it should be replaced with a new one.
To replace the battery, you will need a narrow shaft
Phillips type screwdriver and a replacement battery
(GMC Part VEC117-AUBAT). The battery pack can be
replaced by doing the following:
1. Remove the rubber end cap from the back of the body,
noting the location of the Recharge Port (fig. O).
2. Remove the four Phillips screws (clockwise) that fasten
the inner hard plastic end cap (fig. P).
G H
I J
K L
M N
O P