Garmin ZUMO 400 EN - Manual (Page 44)

 zūmo 400/450 Owner’s Manual
a
PPendix
2. Plug the power cable into the side of
the mount.
3. Place the zūmo into the automotive
mount, and flip the lever down.
Lever
Sucton
cup arm,
lever back
Mn-USB
port
Audo jacks
4. Plug the power cable into a power
receptacle in your vehicle. Your zūmo
should turn on automatically if the
vehicle is running.
Mounting on Your Dashboard
Use the mounting disk to mount your
zūmo on the dashboard and to comply
with state regulations.
notE: The permanent
mounting adhesive is extremely
difficult to remove after it is
installed.
1. Clean and dry the dashboard where
you want to place the disk.
2. Remove the backing from the
permanent mounting adhesive on the
bottom of the disk.
3. Place the disk on the dashboard.
4. Place the suction cup part of the
automotive mount on top of the disk.
5. Flip the suction lever down (toward
the disk).