Gemini XTR-400 - Manual (Page 4)

(4)
SETUP:
There are various ways to set up this system:
BASIC SETUP:
Okay, this is your basic setup, perfect for small parties and venues. The
ideal location for your subwoofer is close to a wall or in a corner. This
will give you the fullest bass response. Your 2 satellite speakers can be
placed up on stands on each side (stands must be purchased separately).
TWO-SYSTEM SETUP:
This setup is perfect for larger venues. This setup requires 2 XTR-400
systems. This will give you a total of 800 watts rms! Place a subwoofer
on each side to the left and right. Using the high-hat hardware and
connecting pole (which can be purchased separately), place the
pole in the high-hat socket on the subwoofer, and a satellite speaker on
top of the pole. The 2 remaining satellite speakers may be used as either
floor monitors, or placed on stands elsewhere in the room giving you a
louder and fuller sound.
Each speaker system in this setup must be used in MONO mode (see
Mono section). Connect the system that is on the left side of the audience
to the LEFT channel of your mixer, and the system that is on the right side
of the audience to the RIGHT channel of your mixer.
ACTIVE SPEAKER SYSTEM SUBWOOFER/SATELLITES
The XTR-400 features a unique design for ease in transporting. The 2
satellite speakers conveniently fit into a special recessed section of the
subwoofer and are securely fastened using a strap that attaches to the
handles (included).
SHOULD YOU EXPERIENCE ANY DIFFICULTIES OR PROBLEMS,
PLEASE CALL: 1 (732) 738-9003 FOR GEMINI CUSTOMER SERVICE.
SPECIFICATIONS:
Subwoofer XTR-400SUB:
Amplifier’s Output Power:.........................230 Wrms on subwoofer channel
Frequency response:……………………...........................….32 Hz - 100 Hz
Components:………………………...........................……………..15" woofer
Features:
Efficient band-pass cabinet design
Large metal handles
Metal protection corners
Four 2" wheels
Amplifier assembly on the back
35mm standmount cap on top
Black carpet finish
Rubber feet
Dimensions:..............................................................WxDxH: 20"x31"x24.5"
(508 x 788 x 622 mm)
Weight:…………………............................……………………..96 lbs (44 kg)
Satellites GT-1002s:
Amplifier’s Output Power:..........................2x85 Wrms on satellite channels
Frequency response:…………............................………….100 Hz – 20 kHz
Components:….…………...........................……………………….10" woofer
6” dual piezo horn
Features:
Trapezoidal cabinet
Full front protective metal grill
Metal protection corners
35 mm standmount cup on the bottom
Black carpet finish
Rubber feet
Neutrik Speakon connector
Dimensions:……….……..............................…….W x D x H 12.5" x 9" x 18"
(318 x 229 x 458 mm)
Weight:……………………...........................………………18 lbs (8 kg) each
Total System:
Maximum SPL, continuous:……...........................……………………120 dB
Sensitivity………………………...........................……………………. 1 Vrms
Input Impedance………...............10 kOhm unbalanced/20 kOhm balanced
Features:
Balanced XLR and 1/4" Jack inputs
Neutrik Speakons on Satellite Channels’ outputs
Active electronic X-over (Fx=100 Hz)
Variable speed fan
Individual channel Sensitivity/Volume controls
Signal Ground lift switch
110-120 VAC / 220-240 VAC switchable
Total Weight:……………............…...............………………...132 lbs (60 kg)
SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITHOUT
NOTICE FOR PURPOSE OF IMPROVEMENT.