Grizzly Low Profile Cement T10095 - Manual (Page 16)

-14- t10095 Cement Mixer
• Always unplug the cement mixer before
cleaning.
• Avoid getting water on the motor or switch
while cleaning. if you do, allow the compo-
nents to thoroughly dry before plugging in the
motor.
• the easiest way to clean the drum is by
hosing it out with water. (Cleaning is made
much easier if you follow the
Lubrication
procedures in this section before using your
cement mixer.)
• Always clean the mixing drum immediately
after using it. As a general rule, the sooner
you clean, the easier it will be.
• For tough to remove buildup, use a stiff bristle
brush or a rag to make cleaning easier.
• Small, hardened cement splatters usually
can be removed by rubbing with a dry rag.
• hardened cement can be scraped, chiseled
or pounded off with a hammer; however,
these actions Will damage the surface area
of the drum, making it harder to clean in the
future.
Cleaning
SECTION 5: MaINTENaNCE
always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious personal
injury.
Before every use, and while the mixing drum and
blades are clean and dry, wipe down the inside
of the mixing drum and blades with a light coat of
vegetable oil. this will prevent most cement from
sticking to these surfaces and will make cleaning
very easy.
A faster alternative to wiping the oil on would be to
spray it on with a commercial sprayer.
Lubrication