Global Machinery Company LT550 - Manual (Page 5)

5
Power tool use and care
• Do not force the power tool. Use the correct power
tool for your application. The correct power tool will
do the job better and safer at the rate for which it was
designed.
• Do not use the power tool if the switch does not
turn it on and off. Any power tool that cannot be
controlled with the switch is dangerous and must be
repaired.
• Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
• Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
• Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
• Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power tool
for operations different from intended could result in a
hazardous situation.
Service
• Have your power tool serviced by a qualified repair
personnel using only identical replacement parts.
This will ensure that the safety of the power tool
is maintained.
Additional safety rules for line trimmers
• Always wear adequate protective clothing when
operating the machine to avoid injuries to face, eyes,
hands, feet, head or hearing. Use safety glasses or a
face shield, high boots or sturdy shoes, long trousers,
work gloves, a hard hat and hearing protection.
• When starting up and when the machine is in
operation, keep the cutting section away from all parts
of the body, especially the hands and feet.
• Do not start the machine when it is upside down or
when it is not in the operating position.
• Switch the motor off and pull out the plug when the
machine is not being used, left unattended, being
cleaned, being moved from one place to another or
when the spool is being changed or the length of line
manually adjusted.
• If there is an interruption to the power supply or the
extension cable is damaged, switch off the machine
immediately and remove the plug from the power
point.
• Do not move the machine by pulling on the electrical
cable. Always use the handgrip.
• Do not operate the machine near people, especially
children or pets. Turn it off if they get too close.
Maintain a safe distance of at least 5m from other
people when using the machine.
• Keep a balanced and stable stance while using the
machine.
• Ensure that the area being cut is free from strings,
stones and debris.
• Do not cut against hard objects. This could cause injury
to the operator and damage to the machine.
• Never use the machine without the guard. Never use
the machine if the guard is damaged.
5