GSI Outdoors PNEG-214 - Manual (Page 12)

12 PNEG-214 12'-18' Cor-Lok and Cut-Lok Flooring
4. Flashing Installation
Figure 4A
Grain Systems Formed Flashing Installation
If a bin sweep auger will be used, overlap flashing so that the sweep with climb up on to the next flashing
section when rotating (usually clockwise).
(See Figure 4A.) This will prevent the rotating/slipping outer
wheel of the sweep from catching on the flashing edges. (All GSI power sweeps and carry-in sweeps
manufactured after April 2002 run clockwise.)
After floor is in place, place 1-1/4" bolts through pre-punched holes in sidewall. Bolt heads should be on
outside of bin.
See Figure 4B to determine the correct sequence for placing the nuts and washers. Finger
tighten the nuts until all flashing is installed, then go back and fully tighten. While holding the flashing flat
and pushing in towards the bin wall, fasten the flashing to the floor with two sheet metal screws.
Figure 4B