GE PROFILE PDE9900 - Manual (Page 15)

– 15 –
To remove the reservoir:
Note: Removing the reservoir access collar causes
structural damage to the collar. It must be replaced
with a new part # WD35X10059.
Remove the door panel. (See Door Panel .) Insert a
small fl at-blade screwdriver into the slot in the side
of the retaining collar and push the screwdriver
handle counterclockwise while turning the reservoir
access collar counterclockwise a quarter turn.
Remove the retaining collar. Unplug the tube from
the reservoir outlet and disconnect the sensor from
the control module.
Note: The dispenser tank comes as an assembly.
It includes the sensor with wire harness, gasket,
and retaining collar. The complete assembly part
number is WD35X10058.
SmartDispense TM
SmartDispense TM is a bulk liquid detergent dispense
assembly consisting of the following components:
Detergent Reservoir - Mounted within the inner
door panel
Detergent Level Sensor - Connected to a Low
Detergent LED on the control panel
Positive Displacement Pump - Injects
the optimal amount of detergent into the
dishwasher during each cycle.
Detergent Reservoir
Note: The SmartDispense TM system can only be
used with liquid or gel automatic dishwasher
detergent.
To fi ll the reservoir, push down on the cap covering
the reservoir to engage the ratchet, then turn it
counterclockwise to open.
Position the door at a 30 to 45 degree angle. Fill
the reservoir with a liquid automatic dishwasher
detergent until the detergent reaches the threads
of the reservoir access. The dispenser will hold
approximately 45 ounces of liquid dishwasher
detergent (about 1 to 2 months supply).
Place the cap on the reservoir access threads, push
down, then turn clockwise until the cap is tight.
•
•
•