GE 2 Cubic Foot - Manual (Page 10)

10
Safety Instructions
Operating Instructions
Tr
oubleshooting T
ips
Consumer Support
Installation Instructions
Leveling legs
Bottom
hinge
Plug button
Spacer
Hinge cover
Plug buttons
or screws
Hinge
Preparing to install the refrigerator.
Door Reversal
3 and 6 Cubic Foot Models
1. Remove the small plug button on the
left side of the door top cap.
2. Remove the three plug buttons or
screws on the left side on top of the
cabinet.
3. Remove the plastic hinge cover by
lifting it up by the front edge.
4. Remove the three screws from the
top hinge.
5. Lift the door up and off the bottom
hinge (right side).
6. Tilt the refrigerator cabinet back to
remove the right leveling leg.
7. Remove the screws on the bottom
hinge (right side) and the left leveling
leg. Move the bottom hinge to the left
side and secure it with the screws and
leveling leg.
IMPORTANT: The left leg has a spacer that
must be moved to the right side leveling leg
when the door swing is reversed.
8. Screw the right leveling leg, with the
spacer in place, back in place on the
right side.
9. Position the door on the left bottom
hinge. With the magnetic gasket
holding the door in place, secure the
top hinge with screws.
10. Make sure the door is aligned with the
refrigerator cabinet before continuing.
11. Replace the hinge cover on top of
the hinge.
12. Put the plug button in the hole on the
right side of the door cap.
13. Put the three plug buttons or screws on
the right side on top of the cabinet.