Great Dane Chariot / Chariot LX GDRZ61-27KHE - Manual (Page 56)

Service Electrical - 52
SERVICE ELECTRICAL
Using Booster Battery
MIF TS204
M71044
A - Booster Battery
B - Disabled Vehicle Battery
1. Connect positive booster cable to booster battery (A)
positive post (C).
2. Connect the other end of positive booster cable to the
disabled vehicle battery (B) positive post (D).
3. Connect negative booster cable to booster battery
negative post (E).
4. Connect the other end (F) of negative booster cable to a
unpainted metal part of the disabled machine’s engine,
away from battery.
5. Start the engine of the disabled machine and run
machine for several minutes.
6. Carefully disconnect the booster cables in the exact
reverse order: negative cable first and then the positive
cable.
Replacing Fuse - Carbureted Engines
One 20-amp fuse is located behind the seat area.
MX15336
1. Remove defective fuse (A) from socket.
2. Check metal clip in fuse window and discard fuse if clip
is broken.
3. Install new fuse in socket.
Replacing Fuses - Fuel Injected Engines
c
CAUTION: Avoid injury! The battery produces a
flammable and explosive gas. The battery may
explode:
• Do not attempt to jump start a frozen
battery. Warm to 16 degrees C (60 degrees F).
• Do not smoke near battery.
• Wear eye protection and gloves.
• Keep sparks and flames away.
• Do not connect the negative (-) booster
cable to the negative (-) terminal of the
discharged battery. Connect at a good ground
location away from the discharged battery.
• Do not cross jump the battery, damage to
electronic modules will result.
B A
E
C
D
F
IMPORTANT: Avoid damage! When replacing fuses -
use only a 20-amp fuse or you may damage the
circuit.
IMPORTANT: Avoid damage! When replacing fuses -
use only fuses of the same rating or you may
damage the circuit.
A