Assembly – Global Machinery Company LDP13F12 User Manual

Page 10

Advertising
background image

10

Assembly

1. Place base on floor.
2. Place column assembly on

base and align the 4 holes

in the column assembly with

the holes in the base.

3. Using the 4 10mm diameter

x 46mm long bolts secure

the column support to the

base and tighten with a

16mm wrench.

4. Loosen the screw on the rack

collar using the 4mm hex key.

5. Remove the rack collar by

lifting it up and over the

column.

6. Remove the rack from the

column.

7. Ensure that the 4 knobs

securing the extension tables

are tight.

8. Fully insert the worm gear

shaft into the table support

and engage it on the gear

wheel in the assembly.

9. With the short smooth

section of the rack pointing

downwards, slide the rack

through the round opening

in the table support.

10. Engage the rack on the

gear mechanism found

inside the opening of the

table support.

11. Whilst holding the rack and table support slide both

over the column. Slide the rack down until the rack is

positioned against the lower column support.

12. Fit the rack collar over the

column and bring it down

to the top of the rack.

Ensure the bevel side is

down over the rack.

13. Tighten the rack collar

using the 4mm hex key.

To let the rack slide when

the table is swung left or

right around the column

only tighten the set screw

enough to keep the collar

in place.

14. Fit the motor head over

the column and tighten

the 2 grub screws using

the 4mm hex key. This will

secure the head on the

column.

15. Attach the table handle to the worm drive shaft and

tighten the grub screw using the 4mm hex key.

Advertising