Grundig E100 - Manual (Page 9)

WORKING WITH MEMORY continued WORKING WITH MEMORY continued
17
E100 OPERATION MANUAL
16
ACCESSING WHAT IS STORED INTO MEMORY
There are three ways to access what has been stored into memory:
Direct Memory Access, Memory Search and Memory Auto-scan. These
three methods are described below. When the memory page and
memory preset numbers appear in the upper right corner of the display,
as it will in the descriptions below, the radio is in MEMORY ACCESS
MODE. This mode can be exited any time with a press/release of the
M.Scan/Page button (7).
Direct Memory Access
If you are already on the desired memory page, simply key- in the
memory number with the numeric keypad. For example, if the desired
radio station is in memory number 01, just press ‘0’, then ‘1’, and it
will go to memory 01.
If you first need to change memory pages, see the previous section,
SELECTING/CHANGING MEMORY PAGES.
Memory Search
Memory Search enables manual searching through the memories
within a memory page, as shown below:
1. Press/release the M.Scan/Page button.
2. Use quick, short presses on the Up/Hour or Down/Min. buttons to
search through the memories.
SELECTING/CHANGING MEMORY PAGES
If you are not interested in changing memory pages and wish to
keep the original factory memory page setting, skip this section.
At the factory, the E100 is set up to access memory page 1 when
storing a frequency. You can leave this as-is or change to a different
memory page. We suggest learning first to store stations into
memory page 1 before changing to other pages. To do this, go to
the previous section, STORING STATIONS INTO MEMORY. To change
to the memory page, follow the directions below.
1. Press/hold the M.Scan/Page button (7) for about 3 seconds. Then
release it. Note that the memory page (38) is flashing in the upper
right corner of the display.
2. Within 5 seconds select the desired page with the Up/Hour and
Down/Min. buttons (5,6). You will see the memory page change
with each press. When the page of your choice is reached, stop
pressing.
3. When finished, either press/release the M.Scan/Page button, or
wait about 3 seconds, causing the memory page to be entered.
The clock (34) will reappear in the display’s upper right corner.