Grizzly G0513P User Manual
Page 19
G0513 Series Bandsaws
-17-
Figure 10. other bandsaw components.
d
E
F
g
i
h
G0513X2, G0513X2B, G0513X2BF, &
G0513X2F
Shipping Inventory (Figures 9 & 10): Qty
A. Bandsaw (not shown) ................................. 1
B. table ........................................................... 1
c. Miter gauge ................................................ 1
D. rear rail .................................................... 1
E. resaw Fence ............................................ 1
F. Front rail .................................................... 1
G. Fence assembly ......................................... 1
H. Foot Brake pedal (g0513X2BF
& g0513X2F) .............................................. 1
I. guide post handwheel............................... 1
Hardware & Tools (Not Shown)
Qty
•
Eye Bolt M10-1.5 (May Be installed) .......... 1
•
Flat Washers 8mm (table, Fence, rail) ..... 8
•
lock Washers 8mm (table, rail) ............... 5
•
hex Bolts M8-1.25 x 25 (table) .................. 4
•
hex Bolt M8-1.25 x 90 (positive stop) ........ 1
•
hex Nuts M8-1.25 (positive stop, Fence)... 2
•
Cap screws M6-1 x 20 (rail) ..................... 3
•
Cap screw M8-1.25 x 20 (rail) .................. 1
•
lock Washers 6mm (rail) .......................... 3
•
Flat Washers 6mm (rail) ............................ 3
•
hex Nut M6-1 (Fence) ................................ 1
•
Cap screws M6-1 x 16 (Foot Brake pad) ... 2
•
lock Washers 6mm (Foot Brake pad) ....... 2
•
table pin..................................................... 1
•
table insert ................................................. 1
•
Fence handle M8-1.25 x 44 (Fence) .......... 1
•
rail pad M6-1 x 18 (Fence) ........................ 1
•
Moving plate (Fence).................................. 1
•
rail plates .................................................. 3
•
hex Wrench 5mm, 8mm....................1 Each
•
open End Wrench 10 x 13mm ................... 1
Figure 9. table and miter gauge.
C
B