Garmin NX420 User Manual
Start here, Epson stylus, Nx420 series
Start Here
3
Squeeze the edge guide as you slide it all the way to the
left.
4
Load letter or A4-size paper against the right edge and
behind the tab, with the printable side face up.
5
Slide the edge guide over.
Continue with section 6 to choose your connection type.
Read these instructions before using your product.
1
Unpack
French control
panel stickers
(included for
Canada only)
Power cord
Caution:
Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1
Connect the power cable.
Caution:
Do not connect to your computer yet.
2
Press the
On button.
3
Select language
1
To select
English as your language, press
Start.
Note:
If you want to change the language, press
or
to
select it, then press
Start.
4
Install ink cartridges
Note:
Do not load paper yet.
1
Lift up the scanner, then open the cartridge cover.
2
Shake the ink cartridges gently 4 or 5 times, then unpack
them.
3
Remove only the yellow tape from each cartridge.
Caution:
Don’t remove any other seals or the cartridges may
leak.
4
Insert the cartridges in the holder for each color.
5
Press each cartridge down until it clicks.
6
Close the cartridge cover. Press down until it clicks.
7
Lower the scanner.
8
Press the
Start button to charge the ink.
Priming takes about 2 minutes.
Note:
Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution:
Don’t turn off the printer while it is priming or you’ll
waste ink.
5
Load paper
1
Open the paper support and pull up the extensions.
2
Open the output tray, pull out the extensions, and raise
the stopper.
*411841500*
*411841500*
Epson Stylus
®
NX420 Series