Graco 9047 - Manual (Page 6)

9 364-4-98
10
11
Step 1.
Remove the canopy and
lower the back flap. Apply
locks on wheels. Release the
two VELCRO ® straps under the
Pack ’N Play, and remove the
mattress.
Step 2.
IMPORTANT: Raise center
halfway BEFORE unlocking
rails.
Grasp center loop as shown
and pull up approximately
halfway to the top rails.
Step 3.
The top rail has a center piece with
two tubes hidden under the fabric.
The button on the bottom of the
center piece releases the two
tubes when it is pushed up.
Step 4.
Pull center up all the way.
Step 5.
Gather your unit together.
Do not force.
If unit will not fold, look for
a partially latched top rail.
Squeeze the latch button to
release the rail.
Step 6.
Find the bottom corner belt
loop (only one). This loop is
for holding unit and mattress
together while carrying.
Step 7.
Wrap the mattress around
your unit. Position the mat-
tress so the mattress handle
is on the opposite side of the
wheels. Fasten together the
VELCRO ® straps.
Fold the tubes and canopy,
and fit the tubes and canopy
snugly into the unit. It is not
necessary to remove the
tube from the canopy. Grasp
the tube on either side of a
joint and pull apart. Repeat
at other joint. Fold the tube
and canopy together.
To fold the top rail:
!
Lift up slightly on the top rail.
!
Push up on the button located under the symbol
!
to release the two tubes.
!
Push down.
Place the Pack ’N Play on the
floor with the feet and wheels
facing up.
Pull cover over the unit. Be
sure the carrying handle
attached to the Pack ’N Play
mattress is exposed.
Push the plastic end of bag
over the wheels and feet of the
unit.
Turn the unit over and zip the
bag together.
To Fold Your Pack ’N Play ® To Cover Your Pack ’N Play ®
Handle
Wheel
Foot
Center
piece
Tube
Push UP button
under fabric
HINTS:
!
If top rails do not unlatch, lift
!
the center of the floor higher.
!
Both tubes must be released
!
for the top rail to fold.
Model Number
(Must be filled in)
SHIP TO:
Name
Address
City, State, Zip
( )
Telephone
Total:
6% sales tax
(PA only):
Total amount
due:
Check enclosed
(payable to Graco Children’s
Products Inc.)
Charge to credit card:
Visa
MasterCard
Discover
Account #:
Expiration date:
Signature:
Mattress
Carry bag
Canopy
Canopy tube
Canopy bracket
Toy bag
Wheels
Parts List:
Mattress ..................
Carry bag ................
Canopy ...................
Canopy tube ...........
Canopy bracket ......
Toy bag ...................
Wheels ....................
Price:*
$17.50
$12.00
$15.00
$ 5.00
$ 5.00 (each)/$8.00 (2)
$12.00
$ 7.00 (each)/$10.00 (2)
Return the form below with payment to:
GRACO CHILDREN’S PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
ELVERSON, PA 19520
IF YOU NEED HELP
If you have any questions, please call toll-free:
1-800-345-4109
* Prices subject to change without notice.
Replacement Parts
Instructions for ordering Pack ’N Play ® parts:
Complete form below. Your Pack ’N Play model number
MUST be included on the form to ensure proper replace-
ment parts. Your model number can be found on a label
on the center of the bottom of the unit. Payment must
accompany your order.
12
CARE AND MAINTENANCE
FROM TIME TO TIME CHECK YOUR PACK ’N PLAY
for worn parts, torn material or stitching. Replace or
repair the parts as needed. Use only Graco ® replace-
ment parts.
IF PACK ’N PLAY IS USED AT THE BEACH, you
MUST clean sand off your Pack ’N Play, including the
feet, before packing it into cover. Sand in top rail lock
may damage it.
TO CLEAN PACK ’N PLAY, use only household soap
or detergent and warm water. NO BLEACH.
TO WASH CARRY BAG AND FITTED SHEET
(on certain models), machine wash in lukewarm water
on delicate cycle and drip-dry. NO BLEACH.