GE ZET1 - Manual

1
30 ” (76.2 cm) Built-In
Wall Oven
Installation
Instructions
ZET1, ZET2
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
Before You Begin
Read these instructions carefully and completely.
•
IMPORTANT
—Save these
instructions for local inspector’s use.
•
IMPORTANT
—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
•
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Materials Needed
Strain Relief Clamp
for 1/2
” conduit
Junction
Box
Wire Nuts
36 ” (91 cm)
of String
31-10649-2 07-07 JR
Parts Included
Metal Bottom
Trim Assembly
Tools Needed
1/8 ” Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Adjustable Wrench
(Appearance may vary.)
(8-18 x .750 flat-head
Phillips wood screws)
(8A8 x .625 truss-head
Phillips wood screws)
3/4 ” Wood
Screws
5/8 ” Wood
Screws