GE 25403 - Manual (Page 34)

34
Caller ID
If You Did Not Program Your Local Area Code
1. Use the REVIEW < or > button to display the number you want to dial. You will only see 10-digit numbers (i.e.234-555-1234).
2. Press DIAL to dial back. You may adjust the number format if “Press 65 to adjust ” shows in the display.
Call Waiting Caller ID
This feature allows you to see who is calling when you hear the call waiting beep. The caller identification information appears in the display
after you hear the tone.
• Press the FLASH button to put the person to whom you’re talking on hold and answer the incoming call.
IMPORTANT: To use all the features of this unit, you must subscribe to either the standard Name/Number Caller ID Service or Caller ID with Call Waiting Service. To
know who is calling while you are on the phone, you must subscribe to Caller ID with Call Waiting Service.
Memory Log and Phone Book (Directory) Memory
You may store data in the Phone Book Directory (up to 90 memories) or the Intercom/Memo Log (16 buttons located to the right of the
number pad on the base). The Phone Book and each Intercom/Memory Log stores up to 21 characters and 32 digits.
Storing a Number and Name in Memory
NOTE: To cancel the storing procedure at any time, press EXIT.
1. Press the STORE button. ENTER NUMBER is displayed.
2. Use the touch tone pad on your telephone to enter the telephone number you want to store. The numbers you enter show in the display.
NOTE: If you make a mistake, use the REVIEW < or > button to move the cursor to the incorrect digit, and press the DELETE button to delete.
3. Press SELECT. ENTER NAME is displayed.