Garmin GNS 530 - Manual (Page 14)

GNS 530(A) Quick Reference
INHIBITING TAWS OR TERRAIN
14 190-00181-01 Rev. G
Inhibiting TAWS or TERRAIN:
1) Select the TAWS or TERRAIN Page and press
the MENU Key. ‘Inhibit Terrain?’ is selected
by default.
2) Press the ENT Key. The ‘TER INHB’ annunciation
is displayed in the annunciator field when
TAWS or TERRAIN is inhibited.
Annunciator Field
NOTE: Inhibit mode deactivates TAWS or
TERRAIN alerting when deemed unnecessary
by the pilot. Flying VFR into an area where
unique terrain exists could cause the system to
annunciate nuisance alerts. Pilots should use
discretion when inhibiting the TAWS or TERRAIN
system and always remember to enable the
system when appropriate.
Enabling TAWS or TERRAIN:
1) Select the TAWS or TERRAIN Page and press
the MENU Key. ‘Enable Terrain?’ is selected
by default.
2) Press the ENT Key. The TAWS or TERRAIN
system is functional again.
NAV/Com pAGe
The NAV/COM Page provides a list of the airport
communication and navigation frequencies at the
departure, enroute, and arrival airports.
Departure, Enroute,
or Arrival Airport
Assigned Frequency and
Usage Information
(when applicable)
Frequency
Type
Number of Pages in
Current Page Group
Position of
Current Page
within Current
Page Group
Current
Page Group
Selecting a frequency list for a departure,
enroute, or arrival airport:
1) From the NAV/COM Page, press the small right
knob to activate the cursor.
2) Turn the large right knob to place the cursor
on the airport identifier field (top line on the
NAV/COM Page).
3) Turn the small right knob to select the desired
airport and press the ENT Key.
Scrolling through the list of frequencies:
1) Activate the cursor, if not already active, by
pressing the small right knob.
2) Turn the large right knob to move the cursor
through the list of frequencies. If there are
more frequencies in the list than can be
displayed on the display, a scroll bar along the
right-hand side of the display indicates which
part of the list is currently being displayed.
Auto-tuning a frequency from the NAV/
COM Page:
1) Highlight the desired frequency by scrolling
through the list of frequencies, as described in
the preceding procedure.
2) To place a frequency in the standby field of the
COM or VLOC Window, highlight the desired
frequency and press the ENT Key.
bottom Row ANNUNCiAtoRS ANd
meSSAGeS
See Pilot’s Guide for detailed information.