Configuration guide, Onfiguring, Ht496 – Grandstream Networks HT496 User Manual
Page 15: Through, Oice, Rompt, Dhcp, Static, Irmware, Erver
Grandstream Networks, Inc.
HT496 User Manual
Page 15 of 29
Firmware 1.0.3.86
Last Updated: 7/2007
C
ONFIGURATION
G
UIDE
C
ONFIGURING
HT496
THROUGH
V
OICE
P
ROMPT
DHCP
M
ODE
Select voice menu option 01 to enable HT496 to use DHCP.
STATIC
IP
M
ODE
Select voice menu option 01 to enable HT496 to use STATIC IP mode, then use option 02, 03, 04, 05 to
set up IP address, Subnet Mask, Gateway and DNS server respectively.
F
IRMWARE
S
ERVER
IP
A
DDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
C
ONFIGURATION
S
ERVER
IP
A
DDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
U
PGRADE
P
ROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
F
IRMWARE
U
PGRADE
M
ODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1) always check, 2) check when pre/suffix changes, and 3) never upgrade.
WAN
P
ORT
W
EB
A
CCESS
Select voice menu option 12 to enable WAN Port Wed Access of the device configuration pages.