Garmin XM GDL 69 - Manual (Page 23)

4.3.5
38B
Verify Temperature/Dewpoints
To display Temperature/Dewpoints on the NAV Weather Page:
1.
Select the NAV Weather Page.
2.
Press CRSR. The upper left hand corner data field flashes.
3.
Turn the small right knob and select ‘TEMP/DP’.
4.
Press CRSR. The Temperature/Dewpoints are displayed on the NAV Weather Page similar to
X
Figure
4-7
X
, if available .
Figure 4-7. Temperature/Dewpoints Page
NOTE
For all 400/500 Series units: After verifying that all weather products have been
received, leave unit on for an additional 1.5 hours to allow subscription lock-in process to
take place.
4.4
20B
Refreshing
If the unit is not activated after 1.5 hours a ‘refresh’ maybe needed. To accomplish this go to the website
www.xmradio.com/refresh as explained in Section
X
2.2
X
. When asked for the Radio ID number on the
website, enter the Data ID number and then follow the steps as outlined on the website. If you still are
having trouble, call Garmin technical support using the telephone numbers listed on page iii.
4.5
21B
Deactivating and Reactivating the GDL 69/69A
When the GDL 69/69A is not properly activated, in some cases it may be necessary to perform a full
deactivation and reactivation of the system in order to make it work properly. This procedure is
complicated and should never be attempted without the guidance of Garmin AT technical support
personnel. Please contact Garmin AT technical support using the telephone numbers listed on page iii.
XM Activation Procedures Page 17
190-00355-04 Rev. H