GE ZISS420NXSS User Manual

Ziss420nxss, 429dia8, Ge monogram

Advertising
background image

For answers to your Monogram,

®

GE Profile

or

GE

®

appliance questions, visit our website at

ge.com or call GE Answer Center

®

service,

800.626.2000.

110186

Specification Revised 11/08

Listed by

Underwriters

Laboratories

ZISS420NXSS

GE Monogram

®

42" Built-In Professional Side-by-Side Refrigerator

Dimensions and Installation Information (in inches)

Water and electrical locations

The opening must be prepared with the electrical and water

supply located as shown.
The cutout depth must be 24".

The refrigerator will project forward, slightly beyond

adjacent cabinetry, depending on your installation.
The cutout depth beneath a soffit:

When installed beneath a soffit, the soffit cannot exceed the

24" installation depth shown. The top case trim overlaps the

bottom of the soffit.
Frameless cabinets:

The case trim overlaps cabinets at the top and sides.

Therefore, frameless cabinets may require filler strips to

prevent interference with cabinet door swing. The opening

must allow for filler strips.
Additional Specifications

• A 115 volt 60Hz., 15 or 20 amp power supply is required.

An individual properly grounded branch circuit or circuit

breaker is recommended. Install a properly grounded 3-

prong electrical receptacle recessed into the back wall.

Electrical must be located on rear wall as shown.

Note: GFI (ground fault interrupter) is not recommended.
• Water line can enter the opening through the floor or back

wall. The water line should be 1/4" O.D. copper tubing or

GE SmartConnect

kit between the cold water line and

water connection location, long enough to extend to the

front of the refrigerator. Installation of an easily accessible

shut off valve in the water line is recommended.

The Installation Space

* Shipping height.

The refrigerator

can be adjusted to

fit into a cutout that

is 83-1/2" min. to

84-1/2” max. height.

Note that the top

case trim at the

front is 1/2" higher

and will overlap

upper cabinetry or

soffit. Use leveling

legs and wheels

for a maximum 1"

height adjustment.

Product Clearances

These refrigerators are equipped with a 2 position door stop.

The factory set 130° door swing can be adjusted to 90° if

clearance to adjacent cabinets or walls is restricted.

Allow minimum clearances for freezer door and fresh food

door for a full 130° door swing and to allow for pan removal.
4" minimum clearance is required when door swing is

adjusted to 90°. If the 90° door stop position is used, pan

access is maintained, but pan removal is restricted.
Installation Information: Before installing, consult

installation instructions packed with product, or online

at Monogram.com, for current dimensional data.

19"

130° Door Swing

13"

*Finished Width

6"

5"

Electrical

Area

84-1/2" max

83-1/2" min

Finished

Opening

75" From Floor

to Bottom

of Electrical

Area

24"

5"

5"

3-1/2"

Water Supply

3-1/2"

36" Models 12"

42" Models 18"

48" Models 20"

35-1/2" for 36" models

41-1/2" for 42" models

47-1/2" for 48" models

696Dia15

429Dia8

*84" From

Floor to

Top Frame

42"

Frame to Frame

41"

Case Width

*83-1/2"

at

Rear

25-3/4"

27-3/4"

including

handle

23-7/8"

Behind

Frame

90

° Door Swing

4" Min.

to Wall

28-5/8"

Advertising