Document Outline

• Contents
• Checking Out Your Gateway Server
  • Front
    • Control panel
  • Back
    • I/O panel
  • Interior
  • System board
    • Connectors - right side
    • Connectors - left side
  • Getting Help
    • System Companion CD
    • Gateway Web site
    • Telephone support
• Setting Up Your Server
  • Setting up the hardware
  • Protecting from power source problems
  • Mounting your server into a cabinet
    • Installing the bezel
    • Removing the server from a cabinet
  • Starting your server
    • Understanding the power-on self-test
    • Turning off your server
  • Configuring the RJ-45 serial port
  • Setting up the operating system
  • Initial hardware settings
• Maintaining Your Server
  • Caring for your server
    • Cleaning your server
      • Cleaning tips
      • Cleaning the keyboard
      • Cleaning the screen
  • Preparing for system recovery
    • Recording the BIOS configuration
  • System administration
    • Gateway Systems Manager
    • Server security
      • Locking the server
      • Using BIOS security passwords
  • Identifying your server
  • Updating the baseboard management controller firmware
    • Updating the FRU/SDR
  • Using your System Companion CD
• Installing Components
  • Preparing to install components
    • Selecting a place to work
    • Gathering the tools you need
    • Getting Help
  • Preventing static electricity discharge
  • Opening the server case
  • Closing the server case
  • Removing and installing air ducts, air dams, and baffle
    • Removing the processor air duct
    • Installing the processor air duct
    • Removing the air baffle
    • Installing the air baffle
  • Installing and removing drives
    • Installing a diskette in a converted hard drive bay
    • Removing a diskette drive from the converted hard drive bay
    • Installing a CD or DVD drive
    • Removing a CD or DVD drive
    • Installing or replacing a hard drive
      • Installing a fixed SATA hard drive
      • Removing a fixed SATA hard drive
      • Installing a hot-swap hard drive
    • Configuring your onboard RAID solution
      • Configuring the onboard SATA RAID solution
    • Filling empty drive bays
  • Installing memory
    • Memory online sparing
  • Removing and Installing PCI expansion cards
    • Removing and installing the PCI riser assembly
    • Removing and installing a PCI expansion card
    • Removing and installing a PCI riser connector
  • Replacing a system fan
  • Installing a processor
  • Replacing the power supply
  • Installing or replacing the hot-swap backplane
  • Replacing the CMOS battery
  • Replacing the control panel
  • Replacing the system board
• Using the BIOS Setup Utility
  • Opening the BIOS Setup utility
  • Updating the BIOS
    • Rolling BIOS
    • Recovering the BIOS
  • Resetting the BIOS
    • Resetting BIOS passwords
• Troubleshooting
  • Telephone support
    • Before calling Gateway Customer Care
    • Telephone support
      • Telephone numbers
  • Tutoring and training
  • Safety guidelines
  • Error messages
  • Troubleshooting
    • First steps
    • Battery replacement
    • Beep codes
    • LED information
    • Diagnostic LEDs
      • POST code checkpoints
      • Bootblock initialization code checkpoints
      • Bootblock recovery code checkpoints
      • DIM code checkpoints
      • ACPI runtime checkpoints
    • BIOS
    • CD drive
    • Diskette drive
    • Expansion cards
    • Hard drive
    • Internet
    • Keyboard
    • Memory
    • Modem (telephone dial-up)
    • Monitor
    • Power
    • Processor
• Server Specifications
  • System specifications
  • System board specifications
  • Environmental specifications
  • Additional specifications
• BIOS Settings
• Safety, Regulatory, and Legal Information
• Index
  • A
  • B
  • C
  • D
  • E
  • F
  • G
  • H
  • I
  • J
  • K
  • L
  • M
  • N
  • O
  • P
  • R
  • S
  • T
  • U
  • V
  • W