Gateway ALR 8200 - Manual (Page 20)

10 Gateway ALR 8200 User’s Guide
Basic features
• Intel Pentium
®
II processor (speed depends on the model)
• Autodetection of 66/100-MHz memory bus for all processor
speeds to accommodate processors using either memory bus speed
• SMP design supporting up to two processor modules
• Intel MP Specification V1.1 and 1.4 compliant
• 32-bit PCI and 16-bit ISA bus master
• 64-bit processor and memory data path
• Extended PCI-to-PCI bridge support
• 64-MB Error Checking and Correcting (ECC) memory,
expandable to 1-GB using ECC 72-bit SDRAM DIMMs
• Integrated 2-MB DRAM PCI Graphics (Cirrus Logic GD54M30)
• Eight expansion slots: five PCI, one shared PCI/RAIDport, one
shared PCI/ISA, and one ISA slot
• Integrated PCI Ultra2 SCSI (Adaptec 7890) with two 68-pin
connectors, dual-channel Ultra-DMA PCI IDE interface, and
floppy controller supporting 1.44 MB and 2.88 MB formats.
• RAIDport ready: the shared PCI/RAIDport slot supports the
addition of a RAIDport card to provide RAID capability.
• Low voltage differential (LVD) support for SCSI devices. LVD
SCSI allows faster disk access and greater data integrity
• Power supply unit that supports dual 400 W redundant power
supply modules with hot swap capability. The system ships with a
single module. If you install the optional second module, the power
supply supports load sharing and N+1 fault tolerance.
• Phoenix upgradable Flash BIOS, Year 2000 Ready
• The system is equipped with InforManager™ (IFM), a special
feature consisting of both hardware and software designed to
monitor and report the operating status of the system and its
devices: CPUs, power supplies, RAM, ambient temperatures,
voltages, and fan operation. For further information about the
InforManager™, refer to the InforManager™ User’s Guide.
4078tl.book Page 10 Tuesday, December 22, 1998 2:19 PM