GE Feb-96 - Manual (Page 7)

7
1. Remove the base plate from the
back by placing thumb and fore
finger in the holes and squeezing
before lifting it off.
2. Connect the short telephone line
cord to the unit, and thread it
through the base plate.
3. Reverse the direction of the base
plate and replace it by putting
the tabs into the slots on the top
of the unit first, and then snap-
ping the bottom tabs into place.
4. Connect the short telephone line
cord into the modular jack on the
wall.
5. Slip the mounting holes over the
wall plate posts and slide the unit
down firmly into place. (Wall
plate not included.)
6. Plug the handset cord into the
handset and into the unit, and
then hang up the handset.
7. Set the PULSE/TONE switch
(located on the handset) to TONE
if you have touch-tone service, or
to PULSE if you have rotary dial
service.
Before you begin see page 5 for
Battery Installation information.
3
1
2
4
5
6
W
ALL
M
OUNT
I
NSTALLATION
REVIEW