Garrett Metal Detectors Master Hunter CX Plus - Manual (Page 18)

www.garrett.com  Master Hunter ® CX Plus Owner’s Manual 
When pinpointing, the Master Hunter CX Plus is op-
erating in an All Metal mode, and you can hold the
searchcoil perfectly still with the detector producing
a constant sound.
For most effective electronic pinpointing, place the
searchcoil on the ground to the side of your target.
Press and hold the Pinpoint touchpad. Scan back
and forth across the target, maintaining searchcoil
contact with the ground. You will observe an in-
crease in sound and LCD reading when the target
is directly beneath the searchcoil’s center. You may
also release the touchpad while the coil is over the
target and you will get a coin depth reading.
Coin Depth Measuring
Pinpoint targets as directed above, but keep the
searchcoil in contact with the ground. Move the
searchcoil off to one side of the target and release
the touchpad. The LCD will indicate coin depth in
inches. This reading will hold for about three sec-
onds.
Since the final step in recovery usually entails dig-
ging, it is recommended that you use a probe to help
locate exactly where to dig. Always make as small a
hole as possible. It is quicker, requires less work and
makes refilling holes easier. And, you should always
fill your holes.