Stovax 7125 - Manual (Page 9)

9
MAINTENANCE AND SERVICING
7.1 To maintain the safe use of your stove you may need to
replace a damaged door glass. To complete this operation,
use this method.
7.2 Remove the door, by opening and lifting the door free of
the hinge blocks. Then lie the door face down on a soft flat
surface, to protect the paintwork and glass.
7.3 Using a screwdriver remove the glass clip fixing screws (4).
The old glass can then be lifted clear of the door. (Note
how the 3mm sealing rope is placed between the glass and
the door.) Remember to dispose of the old glass safely.
7.4 Clean and re-paint, the rear door if required. Clean the
screws with light oil or WD40
® , this will aid future removal.
7.5 Fit a new sealing rope between the new glass and the door,
and place the glass into position in the door. Place the glass
fixing clips into position and re-fix with the clean fixing
screws, tighten the screws evenly until the clips hold the
glass. Do not over tighten the clips as this could break the
glass.
7.6 Fit only Stovax ceramic glass, which is suitable to use in
high temperature applications.
7.7 Using the stove with a damaged door glass could cause
dangerous fumes to enter the room, of the stove to overfire,
resulting in damage.
8.1 To maintain the safe use of your stove you may need to
replace a damaged or worn door sealing rope. To complete
this operation, use this method.
8.2 Remove the door from the stove, by opening and lifting the
door free of the hinged blocks. Then lie the door face down
on a soft flat surface, to protect the paintwork and glass.
8.3 Remove the old rope and scrape old glue from the locating
groove. Clean the locating groove with a clean, dry cloth to
remove all old dust and debris.
8. FITTING A NEW DOOR SEAL
7. FITTING A NEW DOOR GLASS
Fixing Screw (x4)
Fixing Clip (x4)
Glass
Glass Seal (3mm)
Joint
Seal 14mm
Seal 14mm
Seal 10mm x 2mm
Door
Fixing Screw (x10)
Fixing Clip (x4)
Fixing Clip Long (x2)
Glass (x2)
Glass Seal (3mm)
Door (x2)
7125
7125
7126
7126
PR7084
PR7085