Grizzly G8030 - Manual (Page 17)

-15- G8030 3 H.P. Overarm Router
Installing the Brake
Handle
The hand brake serves to stop the spindle when
repositioning the workpiece. The machine must
be turned off before you begin applying the brake
to the spindle
1. Slide the brake lever into its hole as shown in
Figure 11 .
2. Tighten the hex head nut to hold the brake
lever in place.
Figure 11 . Installed brake lever.
Lock Screw
Installing the Fence
The fence is used for straight routing and is easi-
ly installed and removed.
1. Place the fence at the location in which it is to
be used as shown in
Figure 11 .
2. Assemble and tighten the fence lock as shown
in
Figure 12.
3 . Assemble and tighten the fence lock on the
other side of the table.
Figure 12 . Fence lock in place.
Always turn off the power switch before
applying the hand brake. Applying the brake
does not disengage the power switch.
Failure to do so will result in damage to the
braking mechanism.
NOTICE
Always stop the spindle with the brake, or
allow it to come to a complete stop before
moving hands near the spindle.