Graco Inc. 223392 User Manual

Instructions-parts list, Spray gun extension

Advertising
background image

GUN NOT INCLUDED

INSTRUCTIONS-PARTS LIST

308–011

Rev A

SPRAY GUN EXTENSION

4050 psi (280 bar) MAXIMUM WORKING PRESSURE

Model 223–390

12 in. (305 mm) long

Model 223–391

18 in. (457 mm) long

Model 223–392

24 in. (610 mm) long

Fits all Graco high pressure spray guns.
(Adapters available for other guns)

Includes DripLess

t

Tip Guard.

Order spray tip separately.

Pressure Relief Procedure
To reduce the risk of serious bodily injury, including
fluid injection, splashing fluid or solvent in the eyes or
on the skin, or injury from moving parts or electric
shock, follow this procedure whenever you shut off
the sprayer, when checking or servicing any part of
the spray system, when installing, cleaning or chang-
ing spray tips, and whenever you stop spraying.

1. Engage the gun safety latch.

2. Shut off the pump and unplug it (or disconnect the

spark plug).

3. Disengage the gun safety latch. Hold metal spray

extension firmly to the side of a grounded metal
pail, and trigger the gun to relieve pressure.

4. Engage the gun safety latch.

5. Open the sprayer’s pressure drain valve, having a

container ready to catch the drainage. Leave the
valve open until you are ready to spray again.

If you suspect that the spray tip or hose is com

-

pletely clogged, or that pressure has not been fully
relieved after following the steps above, VERY
SLOWLY loosen the tip retainer nut or hose end cou-
pling to relieve pressure gradually, then loosen com-
pletely. Now clear the tip or hose.

WARNING

Hazard of Using Fluids Containing Halogenated Hydrocarbons
Never use 1,1, 1–trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids con-
taining such solvents in this equipment. Such use could result in a serious chemical reaction, with the possibil-
ity of explosion, which could cause death, serious bodily injury and/or substantial property damage.

Consult your fluid suppliers to ensure that the fluids being used are compatible with aluminum and zinc parts.

WARNING

GRACO INC.

P.O. BOX 1441

MINNEAPOLIS, MN

55440–1441

E

COPYRIGHT 1990, GRACO INC.

This manual contains IMPORTANT
INSTRUCTIONS and WARNINGS.

READ AND RETAIN FOR REFERENCE.

Advertising
This manual is related to the following products: