Gefen EXT-DVI-2-MDP - Manual (Page 5)

OPERATION NOTES
2
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE DVI TO MINI DP CONVERTER
• The DVI to Mini DP Converter contains a pre-loaded EDID which will be used by
the source to determine the available output resolutions.
• Maximum supported input/output resolution is 1920 x 1200 60Hz.
• This unit is supplied with multiple power adapter connectors for use in multiple
regions. Please refer to your region’s power standards to determine which power
adapter blade is appropriate for use with the DVI to Mini DP Converter.
• This unit is plug-and-play. No conf guration is necessary to operate the DVI to Mini
DisplayPort Converter.
• FCC Statement
WARNING
FCC Regulations state that any unauthorized changes or modif cations
to this equipment not expressly approved by the manufacturer could void the
user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- You are cautioned that changes or modif cations not expressly approved by
the party responsible for compliance could void your authority to operate the
equipment.