Gianni Industries Electromechanical Lock - Manual

Copyright © All Rights Reserved. P-MU-ML-300 Ver. H Publish: 2010.12.24 4 - 1
ML-300
ML-300-SW
Operating Voltage» ML-300: 12 or 24VDC
ML-300-SW: 12~24VDC/AC
Voltage Tolerance» ±10%
Current Draw» ML-300: 280mA/12VDC; 140mA/24VDC
ML-300-SW: 210mA/12VDC; 150mA/24VDC
Version Changeable» Fail-safe or Fail-secure
Operating Temperature» -10~45°C
Humidity» 0~95% non-condensing
Lock bolt sensor switch output» SPDT rated 3A/125VAC
Solenoid testing» Tested to 1,000,000! cycles
Net Weight» ML-300: 800g / ML-300-SW: 815g
Just applicable to vertical installation
Copyright © All Rights Reserved. P-MU-ML-300 Ver. H Publish: 2010.12.24 4 - 4
62mm cylinder for max 42mm door leaf
72mm cylinder for max 52mm door leaf
ш5.0
ш5.0
25
28
150
28
124
250
30
30
5 6 7 8
30
ш5.0
ш5.0
1 2 3 4
Electromechanical Lock
Installation Instruction
Specification Double Swing Doors
Double swing door Outswing Inswing
Version Changeable:
Take out the Screw 1 , release screw 2 , move the
position and then tighten both screws.
“Fail-Safe”
(Power to Lock)
“Fail-Secure”
(Power to Open)
Caution:
Fixing Lug
Allen wrench (1.6mm)
NIB
Lock bolt
Strike Plate
For double swing door For single swing door
Euro profile
key cylinder
Unit:mm Installation Instructions
Do or le
af
Doo
r Fr ame
Door Loop
(Optional)
(Cy
lind er n
ot inc
lud ed )
Align the center line (CL) of the
Alignment CL
Fra me Do or Le af
Do or Le af
Cut out mortise holes for the lock Tighten the fixing lugs with
screws.
Drill and cut the hole for the lock
Connect power cable to the lock
Attach the cover plates for the Install the cylinder Fix the strike plate.
Stud bolt Position Packing Contents
Do not completely remove screw 2 (as marked in the figure)
as the interior solenoid might fall off.
The door loop protects the wiring
from damage at the door hinge.
Attention! Please ensure that the
direction of the template is correct
Do or F ram e
lock body template with the CL of
the door leaf. Ensure the CL of the
strike plate template matches the lock
body CL as closely as possible.
body and strike plate and drill holes
according to the templates. cylinders as shown in the template.
and test before screwing to the
door leaf.
cylinder lock
For fail-safe mode
For fail-secure mode