Graco Inc. Hydra-Clean 800-654 User Manual

Page 8

Advertising
background image

8 308-537

Chemical Injector

BE SURE that all chemicals used in the chemical

injector are compatible with the wetted parts of the hose,

gun, wand and tip, as given in the Technical Data (inside

back cover). Always read the chemical manufacturer’s

literature before using any chemical in this pressure

washer.

WARNING

Observe chemical manufacturer

’s safety

precautions regarding use of goggles, protective

clothing or respirators.

1026 & 1530: A downstream chemical injector is

provided with the pressure washer. Insert the chemical

strainer (attached with clear tubing to the chemical

injector) into the container of chemical. Push the nozzle

holder on the end of the wand away from the gun. This

causes a drop in pressure that actuates the chemical

injector. Pull the nozzle holder to deactivate the

chemical injector and produce high pressure for rinsing.

The flowrate of the chemical is regulated by turning the

chemical adjuctment knob on the injector . Maximum

chemical flow is at a full two turns counterclockwise from

the closed (clockwise) position. T wisting the nozzle

holder will change the spray fan angle.

2340: The chemical injector is an accessory. See the

chemical injector instruction manual.

WARNING

DO NOT attempt to open or close the adjustable

nozzle when the spray gun is in use. Be sure that

the trigger safety latch on the gun is in the ”ON”

position before adjusting to avoid serious bodily

injury or fluid injection.

Check the distance that you will need to hold the spray

nozzle from the surface by test spraying on a scrap of

similar material. For soft surfaces, such as wook, hold

nozzle 3 ft (1 m) from the surface and gradually bring it

closer, checking to see if the high pressure spray is

damaging the surface.

Mist the wet surface with cleaning solution. Let it soak

briefly, then use the high pressure rinse to ”chisel” off the

soil. Keep the nozzle at an angle to the surface and at a

distance determined to be best for the surface. If some

soil remains, repeat the procedure, letting the chemical

soak a little longer . Stubborn soil can be cleaned of f

better with a stronger, heated cleaning solution.

Protect surfaces that might be damaged by the cleaning

solution or the high pressure spray. Rinse the solution

before it dries.

Trigger Safety Latch

WARNING

To reduce the risk of serious bodily injury

,

including fluid injection, splashing in the eyes or

on the skin,

ALWAYS engage the trigger safety

latch whenever spraying stops, even for a

moment.

In the engaged position, the trigger safety latch

prevents the gun from being triggered

accidentally by hand or if it is dropped or bumped.

Be sure the latch is pushed fully down when

engaging it or it cannot prevent the gun from being

triggered. See Figure 2.

Figure 2

TRIGGER SAFETY LATCH SHOWN ENGAGED

TRIGGER SAFETY LATCH SHOWN

DISENGAGED

Advertising