Vitek VT-1379 B - Manual (Page 6)

6
ENGLISH
- Turn on the shaver with the switch
(7).
- Position the shaver at the correct
angle to the skin and move it gradu-
ally down, evening the whiskers.
- Turn off the shaver and move the
trimmer switch to the lower posi-
tion.
Cleaning the shaver
- Press the shaving block locking but-
ton (5) to open the shaving block
(Pic. 4).
- Using the brush (10), clean the
shaving block inside and out, and
also the blade drive (Pic. 5,6).
- The shaving block can be washed
under a stream of warm water (Pic.
6). Dry the shaving block com-
pletely before closing.
Do not allow water into the electric
shaver's body.
After completely dry, close the
shaving block, reinstall the protec-
tive cap (1) and put away for stor-
age.
It is recommended to clean the
shaving heads once every two
months (Pic. 7, 8)
- Turn off the electric shaver.
- Press the locking button (5) and
remove the shaving block (pic.4).
- Turn the ring counter-clockwise
and remove the locking frame.
- Remove and clean the shaving
heads (separately rotating and
non-moving blades).
Do not confuse the rotating and
non-moving blades. This is impor-
tant because the rotating and non-
moving blades of each head adjust
to one-another, which guarantees
the optimal operating characteris-
tics of each pair of blades.
If you accidentally confuse a blade
block, it may take several weeks to
restore optimal shaving character-
istics.
- Clean the rotating blade with the
brush. Use the side of the brush
with the short bristles.
- Clean the non-moving blades with
the brush.
- Replace the shaving heads onto
the shaving block, install the lock-
ing frame and turn the ring clock-
wise.
- Turn the non-moving blades clock-
wise/counter-clockwise to lock
their plastic frame.
- Re-install the shaving block onto
the shaver.
Trimmer
- Clean the trimmer after each use.
- Turn off the electric shaver.
- Clean the trimmer using the brush
(10) included in the package.
- Apply drops of sewing machine or
hair clipper oil to the trimmer every
six months.
Replacing the shaving heads
(Pic. 7, 8)
To achieve optimal results from your
shaver, replace the shaving blocks
every 2 years.
- Turn off the electric shaver.
- Press the locking button (5) and
remove the shaving block (2).
- Turn the ring counter-clockwise
and remove the locking frame.
- Replace the shaving heads, install
the locking frame and turn the ring
clockwise.
1379.indd 6 1379.indd 6 28.02.2006 10:37:41 28.02.2006 10:37:41