Vitek VT-1370 B - Manual (Page 5)

5
RECHARGEABLE SHAVER
DESCRIPTION
1. Protective
cap
2. Shaver block
3. Rotating blades
4. Blade drive
5. Shaver block locking button
6. Shaver
housing
7. Power switch with locking button
8. Charging
indicator
9. Charger
10. Cleaning brush
11. Travel bag
Charging (Fig.1)
Before using the shaver for the first
time or after a long period of disuse, it
should be charged for 6 hours.
- Insert the charger plug (9) into the
charging socket on the bottom side
of the housing and connect the
charger to the electrical network;
the charging indicator (8) will light.
- Supplemental charging cycles of
the rechargeable battery should
not exceed two hours.
Attention!
- Do not charge the rechargeable
batter for more than 10 hours or
in temperatures lower than 0°C or
higher than 40°C, as this can cause
damage.
- If the shaver is not used for more
than 20 days, then it should be
charged for six hours.
Using the shaver
The best shaving results are achieved
if your skin is dry.
Your skin may need 2-3 weeks to
adapt to this shaving system.
- Remove the protective cap (1).
- Turn on the switch (7).
- Lightly touch the skin, moving
around the shaving block using
simultaneous up-down and rotat-
ing motions.
- Turn off the shaver with the power
switch (7), cover the shaving block
with the protective cap (1) and
store the shaver.
Using the trimmer (Pic. 2, 3)
The trimmer is designed for evening
whiskers and caring for mustaches.
- Move the trimmer switch to the
upper position.
- Turn on the shaver with the switch
(7).
- Position the shaver at the correct
angle to the skin and move it gradu-
ally down, evening the whiskers.
- Turn off the shaver and move the
trimmer switch to the lower posi-
tion.
Cleaning the shaver
- Press the shaving block locking but-
ton (5) to open the shaving block
and gain access for cleaning (Pic.
4).
- Using the brush (10), clean the
shaving block inside and out, and
also the blade drive (Pic. 5).
- The shaving block can be washed
under a stream of warm water (Pic.
6). Dry the shaving block com-
pletely before closing. Do not allow
water into the electric shaver's
body. After completely dry, close
ENGLISH
1370.indd 5 1370.indd 5 28.02.2006 10:35:33 28.02.2006 10:35:33